|
|
Post by audiojack on Apr 2, 2020 21:08:38 GMT
For those that don't use an external mixer, how do folks mix their mono and stereo signals into the HPAMP?
|
|
|
|
Post by admin on Apr 3, 2020 4:52:42 GMT
For those that don't use an external mixer, how do folks mix their mono and stereo signals into the HPAMP? I've never had this issue to be honest. I put everything into one 4-4 MIX and from there into the MultiFX and the stereo from there out to my Mixer/Audio interface. I believe a stereo/performance mixer with panning, etc. is in the planning stage. |
|
|
|
Post by audiojack on Apr 3, 2020 8:15:16 GMT
Yes, it gets tricky when you want to hear some mono signals "dry", as it were, and others that you want to pass though the MultiFX
|
|
|
|
Post by martynaudio on Apr 3, 2020 18:25:23 GMT
Presumably you can just patch from the 4-4mix A duplicated outputs to HPAMP IN L / R respectively to split your mono signal to stereo?
|
|
|
|
Post by audiojack on Apr 4, 2020 7:45:59 GMT
can you be more specific? let's say i have 3 mono signals and one stereo signal (from the mutlifx) how would that look? (for the sake of this exercise, use as many mixer 4-4s as you like)
Heh. I missed this thread
|
|
|
|
Post by slowscape on Apr 5, 2020 3:46:53 GMT
I was just going to reply with my thread but looks like you found it  (The solution if you want to keep it all AEM is two mixers)
|
|
bea5t
New Member
Posts: 30 
|
Post by bea5t on Apr 14, 2020 8:41:22 GMT
Hi, I use 2 MULT ports. One for left and one for right. FX L in L-MULT, FX R in R-MULT, mono MixerOut in L-MULT and R-MULT and then from L-MULT and R-MULT to HAMP L / R. You can then adjust the level in the input from the FX and for the mono signals on the mixer.  It's time for Roberts MIXCONSOLE! |
|
pol
Wiki Editors
Posts: 1,349
|
Post by pol on Apr 27, 2020 13:44:12 GMT
YOu can also use the 4ATT/Mix module to combine sounds or CVs...
|
|
