|
|
Post by audiojack on Jul 19, 2020 10:13:21 GMT
Can we have the DIY Module schematics?
I can sort of figure out the pinouts by following the PCB and looking at the labels on the perf board (for ex P11, P12, P13 on the perf board are the pinouts for Pot1 on the PCB), but it would be nice to have the full schematics to avoid any mistakes.
We could add it to the wiki page too.
|
|
|
|
Post by dizzeesatchel on Nov 28, 2022 16:32:27 GMT
Sorry for the bump, but i second this suggestion; I was staring at the DIY board last night trying to figure out where everything goes! I'm trying to cram a *lot* onto that tiny sub-board; thank god it's double-sided...
|
|
|
|
Post by pt3r on Nov 28, 2022 17:27:49 GMT
don't get too ambitous with the underside of the subboard, it gets quite close to the bottom of the case when installing the diy module. #beentheredonethat
|
|
|
|
Post by dizzeesatchel on Nov 28, 2022 21:17:55 GMT
Gosh you're not kidding... ok, rethink time...
|
|
|
|
Post by pt3r on Nov 29, 2022 10:18:08 GMT
Mind you I managed to squeeze an arduino pro board in there so it is possible but then again there funnier ways to spend your time.
|
|
|
|
Post by dizzeesatchel on Nov 29, 2022 11:20:52 GMT
the wiring is going to be fun....  |
|
|
|
Post by robertlanger on Nov 29, 2022 12:10:55 GMT
DIY schematic2.pdf (36.26 KB) Yes, of course! here you go! Will add it to the Wiki too, ofc.
|
|
|
|
Post by dizzeesatchel on Nov 29, 2022 16:38:09 GMT
Thanks, that helps a lot!
I only realised yesterday that each output is doubled so there are only 4 discreet values...i'd planned for 8... but i'm not using any input so will try sending 4 of my 'outs' through the 'ins'. Will be interesting to see if this works at all or if it's a whole big disaster!
|
|
pol
Wiki Editors
Posts: 1,349
|
Post by pol on Nov 29, 2022 21:28:32 GMT
View AttachmentYes, of course! here you go! Will add it to the Wiki too, ofc. Saw already on the DIY module page, have added to the DIY section too.
Pol.
|
|
