|
|
Post by audiojack on Feb 1, 2020 11:23:34 GMT
The blurb for the MS-20 filter says:
"This adaptation of the filter used first in Korg's MS-20 synth for AE modular offers control knobs for cutoff frequency, resonance and CV attenuator. Two signal inputs for different signal levels control the "drive" of the module. Compared to the wasp filter this filter has a significant self resonance and also a very quick response to changes in the cutoff frequency."
What do CV1 and CV2 inputs control, the Cutoff and Resonance?
I take it this the low pass filter. Would be neat to have the high pass ms-20 filter too.
|
|
|
|
Post by robertlanger on Feb 1, 2020 11:33:46 GMT
CV1 goes through the CV1 attenuator pot, CV2 is an additional CV in without attenuator. Both are for modulating the frequency.
Yup, the Highpass option should get added in the next batch. The module was a bit of a quick shot ;-)
|
|
|
|
Post by audiojack on Feb 1, 2020 13:02:52 GMT
Oooo, excellent. Will the new MS-20 (you heard it here first  ) be like the NYLE, with LP and HP and a mixed out? If you haven't decided yet, it would be cool to have the HP and LP outputs split instead of mixed, so that you could put the output of one into the other. Will we be getting CV control for the resonance? |
|
|
|
Post by arti on Feb 11, 2020 14:59:17 GMT
CV1 goes through the CV1 attenuator pot, CV2 is an additional CV in without attenuator. Both are for modulating the frequency. Yup, the Highpass option should get added in the next batch. The module was a bit of a quick shot ;-) when the next batch will hit the store? I would like to buy couple of modules but I'm willing to wait with my order for the improved MS-20 filter. |
|
|
|
Post by robertlanger on Feb 12, 2020 21:25:16 GMT
Oooo, excellent. Will the new MS-20 (you heard it here first ) be like the NYLE, with LP and HP and a mixed out? If you haven't decided yet, it would be cool to have the HP and LP outputs split instead of mixed, so that you could put the output of one into the other. Will we be getting CV control for the resonance? Unfortunately separate outputs are not possible by design for the MS-20 filter; most likely there will be a switch for LP/HP mode. |
|
|
|
Post by robertlanger on Feb 12, 2020 21:27:40 GMT
CV1 goes through the CV1 attenuator pot, CV2 is an additional CV in without attenuator. Both are for modulating the frequency. Yup, the Highpass option should get added in the next batch. The module was a bit of a quick shot ;-) when the next batch will hit the store? I would like to buy couple of modules but I'm willing to wait with my order for the improved MS-20 filter. Will make a prototype end of this month and a new batch should be produced in the first half of April, if everything goes smooth. |
|
|
|
Post by audiojack on Feb 12, 2020 21:52:23 GMT
Oooo, excellent. Will the new MS-20 (you heard it here first ) be like the NYLE, with LP and HP and a mixed out? If you haven't decided yet, it would be cool to have the HP and LP outputs split instead of mixed, so that you could put the output of one into the other. Will we be getting CV control for the resonance? Unfortunately separate outputs are not possible by design for the MS-20 filter; most likely there will be a switch for LP/HP mode. that's fine, i'll just get two  |
|
) be like the NYLE, with LP and HP and a mixed out?
