|
|
Post by audiojack on Sept 29, 2019 16:41:54 GMT
I'd like to get a 12*2 AE Modular case, which is the same width as a Microbrute, and play around with the Microbrute and the AE Modular together.
One challange I will have is how to keep the AE Modular Case upright behind the Microbrute.
Would be cool to have some sort of angle stand that can be screwed into the 12*2 AE Modular case (where the case hinges go), a bit like the crosses and handbar of the Rackbrute.
Any ideas?
|
|
|
|
Post by NightMachines on Sept 29, 2019 17:10:23 GMT
|
|
|
|
Post by audiojack on Sept 29, 2019 17:16:05 GMT
heh thanks. I did a forum search for "stand" and nothing came up. must have been a typo
|
|
|
|
Post by thetechnobear on Oct 29, 2019 19:27:23 GMT
at one point I had some AE modules in my Eurorack ( with adapter) when it was vertical, and I had issues with the some patch cables not staying in.
so you may want to test that it’s ok in a vertical position.
That said, my tests were with older modules ( so plastic headers) and also prior to the improved patch wires - so it may be ok now.
|
|
|
|
Post by admin on Nov 6, 2019 21:49:36 GMT
at one point I had some AE modules in my Eurorack ( with adapter) when it was vertical, and I had issues with the some patch cables not staying in. so you may want to test that it’s ok in a vertical position. That said, my tests were with older modules ( so plastic headers) and also prior to the improved patch wires - so it may be ok now. With the new patch wires there will definitely not be a problem with them ever falling out by themselves! Especially in the old sockets they sit quite tight. |
|
