|
|
Post by samekid on Nov 14, 2023 17:38:32 GMT
hi all,
can anyone explain me, when using the master module, how can I patch up the ae modular system to process sound from my daw, so out of my sound card into the ae system, then back out to the sound card.
it's a bit confusing with the small wire patch points for audio i/o 1 en 2 and the minijack i/o points, being both in and out, then how am i supposed to know how to patch this?
thankssszzz
|
|
|
|
Post by solipsistnation on Nov 14, 2023 18:14:33 GMT
DAW output to 1/8" Audio 1 IO jack; that gets it into the system, and the audio signal will show up on the A1/Audio 1 patch point at the top of the outputs. Then run audio back into the A2/Audio 2 patch point at the second spot down on the master module, and the audio will show up on the Audio 2 IO jack, which you can then patch back into your DAW. If you want stereo, you can get a 4IO module and use that. The jacks on both 4IO and MASTER are set up as both inputs and outputs and will in general do the right thing. Here's the doc for it: wiki.aemodular.com/pmwiki.php/AeManual/MASTERwiki.aemodular.com/pmwiki.php/AeManual/4IOBasically, patch it up in a way that looks right and it should be fine. |
|
cpruby
Junior Member
Posts: 65
|
Post by cpruby on Nov 27, 2023 0:23:04 GMT
I hope this helps!  |
|
|
|
Post by feijai on Nov 27, 2023 8:54:59 GMT
That diagram implies that audio 1 is used for both in and out on the modules, doesn't it? Which isn't right...
|
|
|
|
Post by dizzeesatchel on Nov 27, 2023 10:24:38 GMT
Hmm, the red arrow coming out of 'AE modules' should be pointing to the highlighted socket, right? It's currently pointing to CTRL 1 which is better used for CV than audio.  |
|
|
|
Post by admin on Nov 27, 2023 10:39:06 GMT
That diagram implies that audio 1 is used for both in and out on the modules, doesn't it? Which isn't right... the I/O 3.5mm sockets on the Master and 4I/O module can be used for either incoming or outgoing signals. It just depends how you'll patch it afterwards. |
|
