|
|
Post by arti on Apr 25, 2019 10:41:38 GMT
When I've bought my 2 rack (used) I received several stickers with AEM logo. One of them differs from the others - it's bigger and on the back side of the paper there are words in german "Siebdruck & Werbetechnik". I suppose I can print it somehow, but could someone explain how to do it properly?
|
|
|
|
Post by robertlanger on Apr 26, 2019 17:24:27 GMT
Usually, you can peel off the transparent layer together with the black layers and then stick it to a clean, flat surface and press it on well - after that you can peel off the transparent sheet leaving the logo on the surface.
These stickers are a bit old now; if the first step fails (black letters do not stick on the transparent sheet any more) then try rubbing/pressing the whole sticker quite hard (with the fingernail or sinilar) to get the black letters stick to the transparent sheet again. Hope it works, otherwise let me know!
|
|
|
|
Post by arti on Apr 26, 2019 18:21:24 GMT
Usually, you can peel off the transparent layer together with the black layers and then stick it to a clean, flat surface and press it on well - after that you can peel off the transparent sheet leaving the logo on the surface. These stickers are a bit old now; if the first step fails (black letters do not stick on the transparent sheet any more) then try rubbing/pressing the whole sticker quite hard (with the fingernail or sinilar) to get the black letters stick to the transparent sheet again. Hope it works, otherwise let me know! Oh I see how it ment to be. Now the transparent layer comes off without the letters. After pressure some letters tend to cooperate more wilingly but some still doesn't stick to transparent layer. I guess it's time is over. Well, I still have regular stickers to use. |
|
