|
|
Post by williamv on Apr 28, 2023 20:00:53 GMT
hello everyone i want to use the modulators module to control a 2vco\d in the internal env and vca of the modulators but i cant get it to do note on note off. is this because there is no bus gate on this module? i hope you can help me all the very best to you lovely people
|
|
|
|
Post by pt3r on Apr 28, 2023 20:22:45 GMT
A env is either is triggered or gated, this is set via the switch /\ or /-\ position (you see these on the module). So in gated mode your env wil open with a specified attack time and stay open i.e. sustain the sound, as long as the gate signal is present and close over a specific decay time once the gate signal is low. Whereas in trigger mode the env will open with the specified attack time and close with the specific decay without sustaining, once the env received a trigger i.e. a high signal. To send a trigger you can use the square wave lfo of your modulator. the modulator module does not really generate gate signals but can send trigger signals.
|
|
|
|
Post by williamv on Apr 29, 2023 9:15:23 GMT
thankyou so much for your help
|
|
