Substituting (missing) ingredients.

Isn't it a bummer that you're about to cook some tasty tunes and you realize you've run out of  or you're missing a certain module?

Here are some ways you can replace some modules by other modules you might have lying around:

SAW/TRIANGLE wave Oscillator/LFO: take an envelope of the 2ENV module and patch its END trigger to its GT input the out will now produce a saw/triangle wave with a slope and fall configurable by the attack and/or decay pots, the cv inputs, and the slow/fast switch. However you must invert you voltages when patching the ACV and DCV inputs since a higher voltage will result in longer attack and/or decay times and subsequently create a lower pitch. You can also use this setup at LFO speeds.

Logic AND gate: you have these to gate signals and you need to check they're both high but you've run out of logic modules? Use a VCA mdoule and switch it to CV mode. patch one of the gate signals to the IN and the other one to the CV inputs. When both gates/triggers are high at the same time then OUT of the VCA will be high as well.

Bitcrush: patch the signal you want to bit crush into the IN of a S/H module. patch a square wave LFO into the TRIG and you have a bitcrushed version of your incoming signal going out to the OUT of the S/H