|
|
Post by Malibu Interface on Feb 18, 2021 17:13:04 GMT
I can't sync the TOPOGRAPF module.
When I apply a clock ... nothing happens.
It just continues to use the internal clock.
Any idea or recommendation ?
|
|
|
|
Post by MaxRichardson97 on Feb 18, 2021 17:36:06 GMT
Turn the rate pot all the way to the left! That's how to make it accept a CV clock as opposed to internal.
|
|
|
|
Post by keurslagerkurt on Feb 18, 2021 17:42:53 GMT
It's also worth to have a watch at the quickstart manual of MI Grids (of which topograph is a identical clone): mutable-instruments.net/modules/grids/manual/I had to set the triggers to longer gate signals in order to reliably trigger the AE 2Env. |
|
|
|
Post by Malibu Interface on Feb 22, 2021 11:40:27 GMT
Turn the rate pot all the way to the left! That's how to make it accept a CV clock as opposed to internal. Thank you for the advice. It kind of works : I can apply the clock / sync but it looks like strongly dividing it. I can have a "normal" tempo if I apply >300bpm at the input and the result is still quite erratic. Any expertise in this matter ? Thanks again for helping. |
|
|
|
Post by keurslagerkurt on Feb 22, 2021 12:47:56 GMT
You can set the PPQ ('pulses per quarter') for the module by entering in its settings mode. You can check the guide I linked earlier for how to do this exactly.
Pulses per quarter = how many clock pulses the module needs before advancing one quarter note. If you set these pulses lower, your topograph should be faster. If you set it higher, it will run slower.
|
|
