|
Post by joerdie on Nov 4, 2020 20:16:44 GMT
Hello all. I am very new to the modular in general and currently have an AE Modular Starter Rack 2 plus some extras and an Arturia Keystep. I have watched quite a few of The5th Volt youtube vids and have been able to connect the Keystep and play individual notes and Pitch bend them. This has been fun and all but I know that I should be able to pass sequences to the modular and there don't seem to be any guides on that. I think my issue may be that I am unable to ask the question correctly, hence my awful Thread Subject. Can anyone point me in the right direction?
Thanks!
joerdie.
|
|
bahm
Full Member
Posts: 154
|
Post by bahm on Nov 4, 2020 20:29:17 GMT
You can record step sequences on the keystep and then it will play them via midi just like if you would play it.
|
|
|
Post by spacedog on Nov 4, 2020 22:38:35 GMT
Check that you haven't selected "Keyboard Play" mode, which I believe routes the sequencer through the CV/Gate only.
|
|
|
Post by joerdie on Nov 5, 2020 1:06:54 GMT
Both of these responses covered the issue/s I was having. That makes so much sense!. Thank you both!
|
|