|
|
Post by tendigits on Jul 6, 2021 19:49:28 GMT
Looking for help/advice. I'm using Master I/O outs with TRS cords to -> TRS-to-fullsize audio jack adapter cable. I've also tried a 2 TS -> 1 TRS cord to -> fullsize jack adapter.
In both cases, when the pedal is off, I can hear the AE Modular sounds piped through to my speaker just fine. When I click to turn the pedal on, no audio. The pedal is an earthquaker levitation. I've checked that it's powered properly and the light turns on when it's active.
Thanks in advance for any guidance!
|
|
|
|
Post by maydonpoliris on Jul 6, 2021 20:30:31 GMT
G'day tendigits,
Because the Ae audio can be heard in your speakers I'm thinking the Ae I/O set up sounds fine. Make sure the volume on the mixer is up further as some pedals need this.
Have you tried the pedal and is working with any other gear, if not a few thoughts.
Are there 2 inputs A and B. Check plugged into A.
Is there an LFO setting where the volume builds up over time.
Turn up any tone, gain and volume knobs.
I'll keep thinking.
|
|
|
|
Post by tendigits on Jul 6, 2021 20:53:00 GMT
G'day tendigits, Because the Ae audio can be heard in your speakers I'm thinking the Ae I/O set up sounds fine. Make sure the volume on the mixer is up further as some pedals need this. Have you tried the pedal and is working with any other gear, if not a few thoughts. Are there 2 inputs A and B. Check plugged into A. Is there an LFO setting where the volume builds up over time. Turn up any tone, gain and volume knobs. I'll keep thinking. That was it! Such a beginner move to not notice the triangles pointing up and down. I had them in backwards. Thank you!! |
|
|
|
Post by maydonpoliris on Jul 7, 2021 0:05:54 GMT
That's awesome that it's working now. glad to help.
|
|
